#Blackfin usb device driver full#

Maximum timeout per individual block erase: 4096 msДЇlash Device Interface Code description: 0x0001 (x16) Maximum timeout for multi-byte program: 1024 us Maximum timeout for byte/word program: 512 us

#Blackfin usb device driver full#

Typical timeout for full chip erase: 0 ms Typical timeout per individual block erase: 1024 ms Typical timeout for maximum-size multi-byte program: 512 us Typical timeout per single byte/word program: 256 us Vpp Supply Maximum Write/Erase voltage: 9500 mV Vpp Supply Minimum Write/Erase voltage: 8500 mV Vcc Logic Supply Maximum Write/Erase or Write voltage: 3600 mV Vcc Logic Supply Minimum Write/Erase or Write voltage: 2300 mV Primary Algorithm Command Set and Control Interface ID Code: 0x0001 (Intel/Sharp Extended Command Set)ДЄlternate Algorithm Command Set and Control Interface ID Code: 0x0000 (null) Where $BOARDTYPE depends on your Blackfin processorДЄnd $BINFILE is a binary file containing the desired flash content (e.g. Now, enter the following commands to flash e.g. SUBSYSTEMS!='usb', ACTION!='add', SUBSYSTEM!='usb_device', GOTO='kcontrol_rules_end' To tell udev to set the proper permissions on gnICE's device files, add the file /etc/udev/rules.d/les with the following content: Set proper USB permissions for gnICE/gnICE+Д«y default, you won't be able to communicate with the gnICE without root permissions. gnICE can be ordered from Farnel Components.The gnICE JTAG Adapter Cable is an Open Source Hardware, based on the FT2232 chip from Future Technology Devices International Ltd. It's designed to provide reliable JTAG debugging and CFI NOR Flash programming via USB.

The gnICE is a fast and low cost USB JTAG In-Circuit-Emulator for Blackfin processors. 1.4 Programming flash memory with bfin-jtag from the GNU tool chain.1.3 Set proper USB permissions for gnICE/gnICE+.